Arduino Uno and Breadboard Holder
Sold by Colton's Store
$8.99
Print Focal prints and ships this design to you.
Choose product color
This model was made specifically for the "elegoo uno most complete starter kit". But it can be used for any Arduino Uno and 160mm Breadboard. * 3xM3 bolts and 3xM3 nuts is needed to fasten the Uno to the model. (Linked example) * 3 spacer rings should be placed between the Uno and the bottom and aligned with the holes. (Spacer Rings Included) Note: You need to cut off the tabs on the side of the breadboard! Breadboard and Arduino not included!
Additional hardware required (not included)
You will need to purchase these parts separately. Print Focal prints the 3D model only; hardware is not included in your order.
- 3xM3 BoltMcMaster Carr #91292A021Purchase link
- 3xM3 NutMcMaster Carr #90725A020Purchase link
Purchase links are provided by the seller. Print Focal is not responsible for third-party sites or product availability.
Details
- Category
- Electronics
- Material
- PLA
$8.99
Arduino Uno and Breadboard Holder